XFAudio

Immagine prodotto

Descrizione

Using trickle down technology from the award winning C-1000f control amplifier. This remarkably flexible control amplifier, is probbaly the only preamplifier available today that features tone controls that be can be activated orr disengaged from the comfort of your listening chair via the remote control. Three single-ended and two balanced inputs. Five single-ended and two balanced outputs. Phase switch on the front panel. Has Luxman's latest compact version of the LECUA 1000-WM volume control (LUXMAN Electric Controlled Ultimate Attenuator with Weighting Matrix Technology). as well as the electronic input selector. Luxman’s most advanced ODNF circuit is employed, release 2.4. as featured in the C-1000f, delivers state-of-the art musical performance.

There is a tape processor loop as well as fully adjustable bass & treble controls from the remote control.

The phase of each balanced input can be set individually. As can the phase of the balanced outputs. There is an overal phase adjustment also availble from both the front panel and the remote control.

The delicate music of the low level signal is protected from unnecessary vibration and degradation, by the installation of cast iron pillars for supporting the chassis.

The balance between the right and left channels can be adjusted from the remote control.

Custom parts, such as resistors & condensers are used extensively throughout this design. Kappa alloy RCA sockets are used because of their high conductance & low resistance. Luxman have used EI transformers for over fifty years.

Specifiche tecniche

Input Sensitivity / Input Impedance: 300mV／67.0KΩ Single-ended / mV/47.5K 300 ohms, Balanced / mV/67.0K 300 Ω
Output / Output Impedance: Single-ended / rated 1 V/564 Ω maximum 5.8 V, Balanced / rated 1 V/600 Ω maximum 6.2 V
Total Harmonic Distortion: Single-ended / 0.009% (20 Hz ~ 20KHz), Balanced / 0.018% (20 Hz ~ 20KHz)
Frequency Response: 20 Hz to 20KHz (+0, - 0.1dB), 5Hz to 116KHz (+0, - 3.0dB)
Signal / Noise Ratio: Single-ended / 123 dB (A-IHF), balance / 120 dB (A-IHF)
Inputs: 5 x RCA Single-ended, 2 x XLR Balanced inputs
Outputs: REC、on RCA. 2 x RCA Single-ended, 2 x XLR Balanced outputs
Front Panel: Stand-by / Operate Switch, Input Selector, Volume control and monitor switch. Output Mode & Balanced Invert switches.
Rear Panel: Main power switch and signal ground post, Remote Output RJ-11 (two) Phase-line sensor, AC inlet.
Remote Control functions: Stand-by / Operate Switch, Input Selector, REC input, Volume up / down, mute, output mode, phase invert, balance, Display Dimmer, preset channels, tone controls, REC output
Power Consumption: 21 W (Normal Operation), 2.3 W (Standby)
Dimensions: 440 mm x 117 x 400
Weight: 13.0 kg
Accessories: Remote Control (RA-60), power cables (JPA-10000)

Recensioni