XFAudio

Immagine prodotto

Descrizione

Using trickle down technology from the award winning C-1000f control amplifier. The C-800f is a fully balanced design. Three single-ended and three balanced inputs. Two single-ended and two balanced outputs. Phase switch on the front panel. Has Luxman's latest compact version of the LECUA 1000-WM volume control (LUXMAN Electric Controlled Ultimate Attenuator with Weighting Matrix Technology). as well as the electronic input selector. Luxman’s most advanced ODNF circuit is employed, release 2.4. as featured in the C-1000f, delivers state-of-the art musical performance.

There are four channels of amplification / attenuation on board. One can choose between two individual pairs of single-ended outputs, which can then be set to different output levels, such as in a bi-amplified system or use all four channels for the fully differentially balanced outputs.

Utilizes 100 millimicron thick gold-plated peel coat PCB which reduces resistance to a minimum in all audio circuits.

The delicate music of the low level signal is protected from unnecessary vibration and degradation, by the installation of cast iron pillars for supporting the chassis.

Has a robust amplifier section capable of driving any amplifier, uses 6,600μF of capacitance. Up to 11 volts are available per channel in balanced mode.

The balance between the right and left channels can be adjusted from the remote control.

In single ended mode; two pairs of outputs are available, which can be adjusted individually from each other, for example, a 6 dB difference between both outputs can be set to allow for the different gain structure of two different amplifers in a bi-amping situation.

Custom parts, such as resistors & condensers are used extensively throughout this design. Kappa alloy RCA sockets are used because of their high conductance & low resistance. Non-magnetic, gold plated AC inlet.

The florescent display shows the different modes as well as source selection and the volume setting, is crisp and easy to read. It may also be dimmed from the remote control.

Specifiche tecniche

Input Sensitivity / Input Impedance: Single Ended 300mV/47.5KΩ, Balanced 300mV/95.0KΩ
Output / Output Impedance: Single Ended rated 1V/564Ω maximum 5.5V, Balance rated 1V/1,128Ω maximum 11V
Total Harmonic Distortion: Single Ended 0.009% (20Hz~20KHz), Balanced 0.005% (20Hz~20KHz)
Frequency Response: 5Hz~20KHz +0, - 0.1dB; 1Hz~117KHz +0, - 3.0dB
Signal-To-Noise Ratio: Single Ended 123dB (IHF-A), Balanced 126dB (IHF-A)
Input: Single Ended - 3 systems, Balanced - 3 systems
Output: Single Ended - 2 systems, Balanced - 2 systems
Front panel: Operation switch, input selector, Volume control and fluorescent display, Output mode switch and balance phase Change-over Switch
Rear panel: Main power switch and signal ground terminal, Remote output (2 systems on RJ11), line phase sensor, AC inlet
Remote control function: Operation and input selector, volume rise/down, mute, Output mode, phase change, dimmer and channel pre-setting
Power supply voltage: AC 240V (50/60Hz)
Electric power consumption: 24W (fully operational), 2.3W (stand by)
External size: 440 × 117 × 427
Weight: 17.6 Kg
Accessories: Remote control (RA-80), power cable (JPA-15000)